道默 PA66 66C-M

增韧级

📋 产品简介

💪

优异力学

拉伸强度70MPa，冲击强度12kJ/m²

🔥

优异性能

🧪

耐化学品

耐油耐溶剂，优异耐疲劳性

📐

尺寸稳定

优异尺寸精度和稳定性

⚡

高性能

满足高端应用要求

🔧

易加工

良好的注塑/挤出加工性

🚗

高韧齿轮

⚡

卡扣

🏭

运动器材

🏭 道默 · PA66 66C-M · 增韧级

数据来源：道默官方技术资料

干燥建议：PA66吸湿性强，必须充分干燥，否则制品易出现气泡、银纹，力学性能下降。建议使用除湿干燥机。

推荐干燥温度 80~100°C，干燥时间 4~6小时，含水率控制在 < 0.1% 以下。

注意事项：PA66熔点较高(约260°C)，加工温度需高于PA6；玻纤增强级加工温度可提高10~20°C；成型收缩率受玻纤含量影响较大。
* 以上参数为 PA66（尼龙66）通用参考范围，实际参数需结合具体牌号、制品结构、模具设计和设备条件进行试模验证。

If you have any questions about Dommer PA66 66C-M Toughened grade polyamide, or would like to request Dommer PA66 66C-M Toughened grade polyamide datasheet, MSDS, ROHS test report, SGS report, REACH certificate, FDA certificate, EU regulation certificate, UL certificate, or COC/COA report, please call our service hotline +86-192-7986-4570, or click Contact Us to leave us a message.

Dommer PA66 66C-M Toughened grade polyamide Properties, Dommer PA66 66C-M Toughened grade polyamide Product Parameters, Dommer PA66 66C-M Toughened grade polyamide Performance Data, Dommer PA66 66C-M Toughened grade polyamide Factory Report, MSDS, Material Safety Data Sheet, UL Yellow Card, SGS Report, RoHS, Food Grade Certification, NSF Drinking Water Standard, Product Information, Product Performance, Factory Report, Original Packaging, Authorized Distributor, Heat Deflection Temperature, Melt Index, Flow Coefficient, Impact Resistance, Impact Strength, Low Temperature Toughness, Low Temperature Impact Resistance, Melt Flow Rate, Processing Technology, Processing Parameters, Processing Temperature, EU RoHS, German FDA, US FDA, Japan FDA