宇部 PA6 1030FB

超高粘度挤出级

📋 产品简介

💪

优异力学

拉伸强度86MPa，弯曲模量3.0GPa

🔥

优异性能

熔点220°C

🧪

耐化学品

耐油耐溶剂，优异耐疲劳性

📐

尺寸稳定

优异尺寸精度和稳定性

⚡

高性能

满足高端应用要求

🔧

易加工

良好的注塑/挤出加工性

🚗

大口径管材

⚡

板材

🏭 宇部 · PA6 1030FB · 超高粘度挤出级

数据来源：宇部官方技术资料

干燥建议：PA6吸湿性强，未干燥的料会导致制品表面气泡、银纹和力学性能显著下降，建议使用除湿干燥机。

推荐干燥温度 80~100°C，干燥时间 4~6小时，含水率控制在 < 0.1% 以下。

注意事项：PA6结晶速度快，模温影响结晶度和尺寸稳定性；玻纤增强级加工温度可提高10~20°C；制品吸水后尺寸会变化，设计时需考虑。
* 以上参数为 PA6（尼龙6）通用参考范围，实际参数需结合具体牌号、制品结构、模具设计和设备条件进行试模验证。

If you have any questions about Ube PA6 1030FB Ultra-High Viscosity Extrusion Grade Polyamide, or would like to request Ube PA6 1030FB Ultra-High Viscosity Extrusion Grade Polyamide datasheet, MSDS, ROHS test report, SGS report, REACH certificate, FDA certificate, EU regulation certificate, UL certificate, or COC/COA report, please call our service hotline +86-192-7986-4570, or click Contact Us to leave us a message.

Ube PA6 1030FB Ultra-High Viscosity Extrusion Grade Polyamide Properties, Ube PA6 1030FB Ultra-High Viscosity Extrusion Grade Polyamide Product Parameters, Ube PA6 1030FB Ultra-High Viscosity Extrusion Grade Polyamide Performance Data, Ube PA6 1030FB Ultra-High Viscosity Extrusion Grade Polyamide Factory Report, MSDS, Material Safety Data Sheet, UL Yellow Card, SGS Report, RoHS, Food Grade Certification, NSF Drinking Water Standard, Product Information, Product Performance, Factory Report, Original Packaging, Authorized Distributor, Heat Deflection Temperature, Melt Index, Flow Coefficient, Impact Resistance, Impact Strength, Low Temperature Toughness, Low Temperature Impact Resistance, Melt Flow Rate, Processing Technology, Processing Parameters, Processing Temperature, EU RoHS, German FDA, US FDA, Japan FDA