UBE Nylon 6 1015B PA6 Polyamide Unfilled General Injection Molding Grade - Product Center - 星空官网入口

UBE Nylon 1015B — PA6 聚酰胺

日本宇部兴产 UBE Industries | 高性能聚酰胺工程塑料

产品牌号UBE Nylon 1015B

产品系列UBE Nylon 6

材料类型PA6 聚酰胺

增强/填充未填充

产品级别通用注塑级

生产厂家日本宇部 UBE Industries

未填充纯树脂PA6，通用注塑级

中等粘度，良好的流动性

耐磨性和耐化学性优异

自润滑性好，脱模容易

UL94 V-2固有阻燃

通用注塑件

机械零件

电子电气壳体

汽车零部件

干燥建议：80~90°C / 4~8小时 / <0.2%

注意事项：PA6吸湿性强，必须充分干燥(含水率<0.2%)；料温过高易黄变，停留时间不宜过长。
* 以上参数为通用参考范围，实际参数需结合具体牌号和模具试模验证。

产品资质：日本宇部兴产 UBE Nylon® 系列PA6 聚酰胺，可根据项目需求提供 TDS 技术资料、SDS 安全资料及原厂技术支持。

环保声明：符合欧盟 RoHS、REACH 法规要求，适用于汽车、电子电气及工业制品生产。

免责声明：以上物性数据基于公开资料和典型应用经验，实际应用请结合具体配方和工艺进行验证。更多产品型号请联系 daoqinsh.com | 数据仅供参考，以原厂最新 TDS 为准。

If you have any questions about UBE Nylon 6 1015B PA6 Polyamide Unfilled General Injection Molding Grade, or would like to request UBE Nylon 6 1015B PA6 Polyamide Unfilled General Injection Molding Grade datasheet, MSDS, ROHS test report, SGS report, REACH certificate, FDA certificate, EU regulation certificate, UL certificate, or COC/COA report, please call our service hotline +86-192-7986-4570, or click Contact Us to leave us a message.

UBE Nylon 6 1015B PA6 Polyamide Unfilled General Injection Molding Grade Properties, UBE Nylon 6 1015B PA6 Polyamide Unfilled General Injection Molding Grade Product Parameters, UBE Nylon 6 1015B PA6 Polyamide Unfilled General Injection Molding Grade Performance Data, UBE Nylon 6 1015B PA6 Polyamide Unfilled General Injection Molding Grade Factory Report, MSDS, Material Safety Data Sheet, UL Yellow Card, SGS Report, RoHS, Food Grade Certification, NSF Drinking Water Standard, Product Information, Product Performance, Factory Report, Original Packaging, Authorized Distributor, Heat Deflection Temperature, Melt Index, Flow Coefficient, Impact Resistance, Impact Strength, Low Temperature Toughness, Low Temperature Impact Resistance, Melt Flow Rate, Processing Technology, Processing Parameters, Processing Temperature, EU RoHS, German FDA, US FDA, Japan FDA